Step 1
Open your two images you are going to need to complete this amazing design.
Crop out the hand and business card from its background, leavin it transparent.
The Hand with business Card and the Hawk.
Step 2
In this second step well are going to cut out the highlighted part of the hawk. Resize the "Hawk" image to fit the "Hand" image. Select the "pentool" and select the part I show below.
Step 3
Once you cut of the selected image-Go to Edit-Transfer-Wrap to fit the image of the hand. Make sure the "hawk" image selected. Go down to the "Hand" image -Ctrl-Click to make a selection of the "hand" image. Once selection is made, go to Select-Inverse 0r (shift-Ctrl-I) and click delete. This well result in a the "hawk" image to fit well around the "hand" image. Erase all the unwated parts that the delete tool did not erase.
Step 4
This should be your result after performing the task above.
Step 5
In this step we are going to cover up the other parts of the hand. So using your pentool cut out the highlighted area. Then rotate it around to the other direction. (rotate 180 degree) Edit-Tranform-Rotate 180.
Step 6
Once rotated line up the lines on the feather to the other feather. On this layer, use the erase tool, lower the opacity to (7), use a soft brush and erase the coners to better blend into the hand and feather. * Always apply a layer mask to any layer you are eraser*. Because if you make a mistake you can easly re-fix
Step 7
After blending the images together, you should result in something simular to below.
Step 8
Crop out the "beak" from the "hawk" image. Then crop out the top beak. Use the pentool to crop.
Step 9
Fit the cut out "beak" to the finger, erase the coners to better blend into finger ( remember add a layer mask) when erasing.
Step 10
Now we will need the bottom "beak". Resize the beak image so it can cover the tumb.
Step 11
Use the erase tool, for a better blend.
Step 12
In the final step you can add any design into the business card. Hope you like it
|
